E-TMC7,EDG7,TG7-I-0710 Operator’s Instruction Manual MODELS TMC-7, EDG-7, TG-7 TMC-7 EDG-7 TG-7 EDGER GRINDER Gasoline/Electric Powered A Division of Equipment Development Company, Inc. 100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA Phone (301) 663-1600 • 1-800-638-3326 Fax (301) 663-1607 • 1-800-447-3326 Website: www.edcoinc.com Email: sales@edcoinc.
E-TMC7,EDG7,TG7-I-0710 READ AND UNDERSTAND THE OPERATORS INSTRUCTION MANUAL THOROUGHLY BEFORE ATTEMPTING TO OPERATE THIS EQUIPMENT. Death or serious injury could occur if this machine is used improperly. SAFETY MESSAGES SAFETY MESSAGES • Safety Instructions are proceeded by a graphic alert symbol of DANGER, WARNING, or CAUTION. Indicates an imminent hazard which, if not avoided, will result in death or serious injury.
E-TMC7,EDG7,TG7-I-0710 Equipment Instruction Manual EDCO Model TMC-7, TG-7 & EDG-7 Table of Contents Section Page Number Specifications......................................................................................................................3 Safety Guidelines................................................................................................................4 Operating Instructions.....................................................................................................
E-TMC7,EDG7,TG7-I-0710 Read and understand all operating instructions before operating this equipment. Death or serious injury can result if this machine is used improperly. Safety Guidelines Eye and ear protection must be worn at all times while the grinder is in use. During normal operation, sound pressure levels may exceed 85dBA. Use only ANSI approved safety glasses to help prevent eye injury. Everyday eyeglasses have only impact resistant lenses; they are NOT safety glasses.
E-TMC7,EDG7,TG7-I-0710 Operating Instructions The EDCO edge grinders are designed to be used in conjunction with other EDCO surface preparation products. It’s small, lightweight construction allows the operator to grind close to obstacles. These units are equipped with a single 7” diameter Diamond Segmented Disc that is an aggressive surface material grinder for removing excess concrete, epoxy mortar, urethane coatings and overlays, and non-skid abrasive coatings on steel, concrete, or polymer slab floors.
E-TMC7,EDG7,TG7-I-0710 For Dry Grinding: Check materials being removed to determine if they are listed on an EPA hazardous substance list. A breathing respirator is required to help protect the operator. • The EDCO VAC-100, VAC-160 and VAC-150 have available optional HEPA filter kits designed to be used when removing hazardous materials. Standard, shop-vac style vacuums are not capable of extended operation. In addition, these standard vacs use paper bag filters that can clog and overload the vacuum motor.
E-TMC7,EDG7,TG7-I-0710 Maintenance Make sure the throttle is completely closed (full stop position) to insure the engine will not accidently fire (kick back) while performing any maintenance. • All maintenance should be performed regularly and by qualified personnel only. • Never work under equipment without first properly securing the equipment to prevent it from moving or falling. Always work on a flat and level surface. • Grease disc bearings every 4 hours of use.
E-TMC7,EDG7,TG7-I-0710 LIMITED EQUIPMENT WARRANTY OF SALE – TERMS & CONDITIONS Equipment Development Company, Inc.
