User guide

Eddy User's Guide

2.5 Eddy-S4M-DK v2.1 (Development Kit)

Eddy-S4M DK is Development Kit supporting programmer can easily materialize and test their application.

DK includes Test Board, various connectors, programming environment and document. Please refer to Eddy-DK

manual for more specific explanation of Eddy-S4M

Classification

Specification

Serial Port

2 x RS232 DB9 Male

2 x RS422/485 5pin Terminal Block (S/W Selectable & with Auto toggle)

SD Card Connector

Push Type, Up to 16 GB

MMC / SD Card / MC supported

MCI Interface

SD Card, MMC Socket

ADC Interface

Light Sensor

USB Connector

1 x Device, 2 x HOST, Dual-Port

LAN Port

RJ45 with transformer

Console Port

DB9 Male

Switch

Power ON/Off switch

Serial RS422/485 Termination resistor configuration switch

GPIO input test switch(Off : Low, ON : High)

LED

RDY, Power, 34 Programmable IO, Console & Serial TxD, RxD LED

JTAG Port

Used for downloading code and single-stepping through programs

Reset Button

Factory Default & Warm Boot

(If pushing over 5sec, operate in Factory default)

JIG Connection

Socket

2 2x23pin socket, which connect to JIG board to check any problems

Expansion Header

2x22pin Header, used to test GPIO of Eddy-S4M

Input Power

5 VDC

Dimensions

160 x 120 mm

2.6 Eddy-S4M-JIG v2.1 (Testing Board)

Eddy-S4M JIG board is test board which enable of user to integrate and test their application with Eddy-S4M.

JIG board include mini connector for joining Eddy-S4M, Ethernet RJ45, USB Host, Power, Reset Switch, and