User`s guide

Chapter 4: Connector References ENCODERS Connector (18 pins)

ENCODERS Connector (18 pins)

The ENCODERS connector allows the instrument to send and receive various

signals such as acquisition start and stop commands, encoder and rotation

synchronization signals, relay outputs, etc.

Figure 4 ENCODERS Connector

Description 18-pin, female, shell 14 connector

Manufacturer, number Amphenol 58-570124-18S

Eddyfi NDT, Inc., MACN4014

Suggested cable connector ITT Cannon, KPT06B14-18P

Amphenol PT06J-14-18P

Eddyfi NDT, Inc., MACN0011

Table 4 ENCODERS connector pinout

Pin I/O Signal Description

A TTL Input B1 Phase B axis 1

B Output CLK_ACQ_OUT Acquisition clock output (open drain with 10 kΩ pull-up)

C TTL Input A2 Phase A axis 2

D – GND Encoders ground

E TTL Input Input 1 User-defined input for software and hardware function

activation.

F TTL Input Input 3 User-defined input for software and hardware function

activation.

G TTL Input Input 2 User-defined input for software and hardware function

activation.

