Turbocharger To Exhaust Manifold Gasket Installation Instructions

Catalog #15015
Rev. 6/05
©2005 Edelbrock Corporation
Brochure #63-0413
TURBOCHARGER TO EXHAUST MANIFOLD GASKET
(For Turbocharger Kit #s 1500, 1501, 1502, 1503, 1504)
Catalog #15015
INSTALLATION INSTRUCTIONS
PLEASE study these instructions carefully before beginning this installation. If you have any questions, do not hesitate to contact
our Technical Hotline at: 1-800-416-8628, from 7am-5pm, Monday-Friday, Pacific Standard Time or via e-mail at:
[e-mail].
DESCRIPTION: Stainless steel gasket used to seal the turbocharger turbine inlet to the exhaust manifold. It can also be used with
any Garrett T25 or T28 Turbocharger.
INSTALLATION
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503
Tech Line: 1-800-416-8628 • E-Mail: [e-mail]
1. When attaching the turbocharger to the exhaust manifold, tighten the nuts in a criss-cross pattern. This will evenly compress
the gasket. Tighten the nuts in a few increments until the gasket is fully compressed.
2. Torque the 8mm x 1.25 nuts to 190 inch/lbs. (approximately 16 ft/lbs).
Catalog #15015
Rev. 6/05
©2005 Edelbrock Corporation
Brochure #63-0413
TURBOCHARGER TO EXHAUST MANIFOLD GASKET
(For Turbocharger Kit #s 1500, 1501, 1502, 1503, 1504)
Catalog #15015
INSTALLATION INSTRUCTIONS
PLEASE study these instructions carefully before beginning this installation. If you have any questions, do not hesitate to contact
our Technical Hotline at: 1-800-416-8628, from 7am-5pm, Monday-Friday, Pacific Standard Time or via e-mail at:
[e-mail].
DESCRIPTION: Stainless steel gasket used to seal the turbocharger turbine inlet to the exhaust manifold. It can also be used with
any Garrett T25 or T28 Turbocharger.
INSTALLATION
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503
Tech Line: 1-800-416-8628 • E-Mail: [e-mail]
1. When attaching the turbocharger to the exhaust manifold, tighten the nuts in a criss-cross pattern. This will evenly compress
the gasket. Tighten the nuts in a few increments until the gasket is fully compressed.
2. Torque the 8mm x 1.25 nuts to 190 inch/lbs. (approximately 16 ft/lbs).