Owners manual

Part #1527, 1528, 15270

Brochure #63-1527

Rev. 5/17/17 - NP

Edelbrock E-Force Supercharger System

2012-16 Jeep Wrangler JK 3.6L V6

Installation Instructions

Page 14

41. Drain about two quarts of coolant to avoid excess

spillage during the next step. This can be done by removing

the lower radiator hose or removing the petcock located

towards the front, passenger side, of the radiator.

42. Unplug the oil cooler sensor connector located in

between the cylinder head flanges. Using a 19mm deep

socket, remove the oil cooler sensor.

43. Using pliers, carefully remove the factory oil cooler

hose from the hard line and oil cooler. This hose must be

replaced with the supplied hose to provide additional

supercharger clearance.

44. Remove the sleeve from the factory oil cooler hose and

install it onto the supplied oil cooler hose. Using the factory

hose clamp, install the straight end of the hose onto the

hard line. Using the supplied worm clamp from Bag #2,

install the other end of the hose onto the oil cooler. Clean

any coolant spillage before proceeding.

Worm Clamp

45. Apply Hi-Temp Thread Sealer to the sensor and

reinstall the oil cooler sensor using a 19mm deep socket.

Reconnect the oil sensor connector.

46. Remove the alternator bracket by removing the upper

bolt with a 16mm socket and the lower bolt with a 13mm

socket.

47. Using a vise, a 1/2” 24mm socket and a 3/8” 9mm

deep socket, carefully remove two bushings from the

factory alternator bracket. Tip: Channellock pliers can be

used if you don’t have access to a vise.

48. Carefully install the bushings into the supplied FEAD

bracket using a vise or equivalent. WARNING: DO NOT use

a hammer as it may damage the bushings and/or FEAD

bracket.