Owners manual

©2015 Edelbrock LLC
Part #1534, 1535
Brochure #63-1534
Rev. 6/2/15 - QT
Edelbrock E-Force Supercharger System
2011-’13 Dodge/Chrysler 5.7L and 6.4L Hemi
Installation Instructions
Page 10
15. Vehicles equipped with 5.7L engines need to install
the supplied fuel pump module at this time. The fuel pump
module installation procedure can be found on Page 28.
16. Raise the front of the vehicle up with a service lift or
equivalent.
17. Use a 10mm socket to remove the 4 bolts retaining the
rear plastic splash shield and remove.
18. Using a panel puller, remove six (6) body pins from the
front splash shield. Some vehicles are equipped with ten
(10) body pins.
19. Using a 7mm socket, remove the nine (9) bolts
retaining the splash shield to the front lip. Some vehicles
are equipped with only seven (7) retaining bolts.
20. Disconnect the lighting harness connector from the
main engine harness if the vehicle is equipped with fog
lamps.
NOTE: Chrysler vehicles disregard Step 21 and proceed to
Step 22.
21. Lift the plastic radiator shroud covers from underneath
the hood latch and put them aside.
22. Dodge vehicles need to remove six (6) body pins,
under the plastic radiator shroud, securing the fascia using
a panel puller.
Chrysler vehicles need to remove seven (7) body pins
securing the fascia using a panel puller.