Owners manual

Part #1534, 1535

Brochure #63-1534

Rev. 6/2/15 - QT

Edelbrock E-Force Supercharger System

2011-’13 Dodge/Chrysler 5.7L and 6.4L Hemi

Installation Instructions

Page 12

NOTE: Dodge Challengers are equipped with a front fascia

supports and a front bumper absorber highlighted in Steps

29-30. Dodge Chargers and Chrysler 300s disregard and

proceed to Step 31.

29. Using a panel puller, remove three (3) body pins

securing the front bumper absorber. Detach the locking

tabs from the front bumper absorber and remove.

30. Using a panel puller, remove four (4) body pins

securing the front fascia support and remove. Proceed to

Step 19.

NOTE: Dodge Chargers and Chrysler 300s are equipped

with a two piece radiator shroud highlighted in Step 31.

Dodge Challengers proceed to Step 32.

31. Using a panel puller, remove four (4) body pins

securing the radiator shrouds. The lower shroud can be

removed from the upper shroud if necessary.

32. Remove the plastic engine covers from the valve

covers by lifting them by the ends.

33. Place a drain pan below the petcock on the passenger

side of the radiator then loosen the petcock and drain the

coolant. Reinstall petcock when radiator is drained.

34. Use a 3/8” drive breaker bar to loosen the tension on

the belt tensioner and remove the drive belt.

35. Remove the driver side PCV hose. Note that the 5.7L

and 6.4L have different driver side PCV configurations.

6.4L

5.7L