Owners manual

Part #1534, 1535

Brochure #63-1534

Rev. 6/2/15 - QT

Edelbrock E-Force Supercharger System

2011-’13 Dodge/Chrysler 5.7L and 6.4L Hemi

Installation Instructions

Page 14

NOTE: Step 45 is only for vehicles with Active Runner

Control. Disregard otherwise.

45. Using electrical tape, tape up the Active Runner

Control connector to prevent any water from contacting the

connector terminals.

46. Using a 10mm socket, remove two (2) bolts securing

each ignition coil. Remove the coils and note their order so

that they can be reinstalled in the same order.

47. Using a 5/8” spark plug socket, remove all 16 spark

plugs. Inspect and replace them as needed, or replace

them with colder plugs recommended before Step 1. Both

stock and new plugs must be gapped to .028”. Apply anti-

seize to the threads of each plug and install. Torque each

spark plug to 7.5-15 ft/lbs.

48. Reinstall the ignition coils in the same location they

were originally and secure them with the stock bolts.

49. Remove the airbox shroud by removing two retaining

pins on the top of the shroud and two (2) on the side of the

shroud.

50. Using mechanic’s wire or equivalent, securely hang

the A/C condenser to the vehicle. Using an 8mm socket,

remove four (4) bolts securing the A/C condenser to the

radiator assembly.

51. Remove all radiator hoses from the radiator if not

already done so. Remove the fan harness and clip from the

radiator assembly. Using a 13mm socket, unbolt the

radiator support brace.

52. With the help from an assistant, carefully lower the

radiator assembly and set aside.