Owners manual

Part #1534, 1535

Brochure #63-1534

Rev. 6/2/15 - QT

Edelbrock E-Force Supercharger System

2011-’13 Dodge/Chrysler 5.7L and 6.4L Hemi

Installation Instructions

Page 15

NOTE: Step 53 is for vehicles equipped with manual

transmissions only. Automatic transmission vehicles can

remove the crank bolt using an impact gun or equivalent.

53. Using a 10mm socket, remove the flywheel dust

cover. Insert an 8mm allen key into the flywheel. Place a

rag in between the allen key and transmission to protect

the transmission surface.

54. Using a 21mm socket and breaker bar, remove the

factory crank bolt. Using the suppled crank bolt, install the

drilling guide with the flat side facing outwards. Position

drilling bushing in a comfortable position for drilling.

Drilling Bushing

55. Mark the supplied drill bit 1.3” from the end of the tip

with masking tape. Using the drilling bushing as a guide,

drill into crank until the tape mark on the drill bit meets the

drilling guide.

56. Use compressed air to clean out any debris present

from the drilling. CAUTION: Use extreme caution when

doing this to make sure debris does not get past the

seal into the crankcase, as this will require a great deal

of disassembly to correct or could cause severe engine

damage if ignored.

57. Loosen the guide bolt and rotate the guide to line up

the reaming hole with the hole drilled. Use the back of the

supplied reamer to center the reaming hole to the drilled

hole. Tighten down the crank bolt to secure the guide and

ream the hole with the supplied reamer.

58. Remove the drilling guide and clean out the hole in the

crank with compressed air. Apply Green Loctite (Red

Loctite can be used if Green Loctite is not available) to the

supplied crank pin and tap it into the hole in the crank.

59. Using a 21mm socket, reinstall the factory crank bolt

and torque to 127 ft/lbs. Remove the allen key and reinstall

the dust cover if applicable.

60. Using a 16mm socket, remove the belt tensioner.

NOTE: Tensioner must be removed to mount the supplied

idler bracket.