Owners manual

©2015 Edelbrock LLC
Part #1534, 1535
Brochure #63-1534
Rev. 6/2/15 - QT
Edelbrock E-Force Supercharger System
2011-’13 Dodge/Chrysler 5.7L and 6.4L Hemi
Installation Instructions
Page 16
NOTE: Step 61-63 are for vehicles with electronic power
steering. Please disregard and proceed to Step 64 if your
vehicle is equipped with a power steering pump.
61. Using a 13mm socket, remove the upper left bolt from
the idler pulley assembly and the water pump bolt directly
above the belt tensioner.
62. Using the short spacer and the bolts from Bag #2,
loosely mount the idler bracket to two bolt hole locations
from Step 48. Using the long spacer and M6 x 110mm bolt
from Bag #2, secure the bracket to the third bolt location;
the provision on the cylinder head above the idler pulley
bolt removed from Step 48. Torque all bolts to 21 ft/lbs.
Socket Head
M6 x 110mm
Short Spacer w/
M6 x 100mm
Long Spacer
63. Using a 13mm socket, replace the grooved pulley on
the factory idler bracket with the supplied 90mm grooved
pulley. Make sure to apply Red Loctite, or equivalent, to the
threads of the factory bolt before installing. Torque bolt to
18 ft/lbs. Proceed to Step 67.
NOTE: Step 64-66 are for vehicles equipped with a power
steering pump. Please disregard and proceed to Step 67 if
vehicle is equipped with electric power steering.
64. Using a 13mm socket, remove the upper left bolt from
the power steering pump and the water pump bolt directly
above the belt tensioner.
65. Mount the idler bracket to the location shown below
using the long spacer and bolts from Bag #2. Torque bolts
to 21 ft/lbs.
Socket Head
M6 x 100
Long Spacer
M6 x 110
66. Using a 16mm socket, install the supplied upgraded
belt tensioner using the factory bolt. Torque to 32 ft/lbs.
67. Install the supplied 76mm idler pulley to the idler
bracket using the M8 x 25mm bolt and M8 washer from
Bag #2. Make sure to apply Red Loctite, or equivalent, to
the threads of the bolt before installing. Torque bolt to 18
ft/lbs.