Owners manual

©2015 Edelbrock LLC
Part #1534, 1535
Brochure #63-1534
Rev. 6/2/15 - QT
Edelbrock E-Force Supercharger System
2011-’13 Dodge/Chrysler 5.7L and 6.4L Hemi
Installation Instructions
Page 17
68. Use a 3/8” Fuel Line Removal Tool to detach the fuel
input line from the factory hard line near the firewall on the
passenger side. Attach the 90° end of the supplied fuel
input line to the factory hard line.
69. Remove the tape covering the intake ports of the
heads and inspect the area to ensure that no residue
remains on the flanges. Lay the supplied manifold gaskets
flat on the intake flanges.
70. Remove the plastic film from the supercharger ports if
not already done so. With the help of an assistant or a
cherry picker, lift the supercharger into the engine bay. Use
the intake bolt holes and injector bores to achieve the best
alignment possible between the engine and the
supercharger.
71. Use a 10mm universal socket to install eight (8) M6 x
30mm intake manifold bolts from Bag #1 following the
sequence shown below. Torque all bolts to 9 ft-lbs in the
same order.
4 1 86
32 57
Front
72. Install the supplied drive belt using the belt routing
diagram below.
IDLER
IDLER
A LT.
CRANKSHAFT
TENS.
WATER
PUMP
S/C
A/C
P/S or
IDLER
73. Apply O-ring lube to the O-rings of the supplied fuel
rail fittings. Install the two straight fittings on the rear
provisions of the rails. Install the 180° fitting on the front
provision of the passenger side rail and the plug in the front
provision of the driver side rail.
Driver side
Passenger side
74. Apply O-ring lube to the upper O-rings of the supplied
fuel injectors, then install them into the fuel rails with the
connectors oriented away from the supercharger.