Owners manual

Part #1534, 1535

Brochure #63-1534

Rev. 6/2/15 - QT

Edelbrock E-Force Supercharger System

2011-’13 Dodge/Chrysler 5.7L and 6.4L Hemi

Installation Instructions

Page 19

83. Attach the supplied passenger side PCV hose to the

front fitting on the passenger side of the air inlet and then

to the PCV fitting as shown.

84. Install the supplied EVAP hose to the EVAP solenoid

and connect the quick connect fitting end to the rear barb

on the manifold as shown.

85. Loosely mount the water pump to the water pump

bracket using the bracket strap and one (1) M8 nut from

Bag #3.

M8 Nut

86. Mount the water pump assembly to the passenger

side frame rail using the supply M8 x 20mm bolts from Bag

#3. The bracket will be sandwiched between the frame

and radiator support.

Inner radiator

support bolt

location.

M8 x 20mm

87. Route the straight end of the Water Pump to LTR hose

under the passenger side head light towards the water

pump. Connect the hose to the outlet of the water pump

and secure with a hose clamp from Bag #3. Securely

fasten the bolt on the water pump strap. NOTE: The other

end of the hose will connect to the Low Temp Radiator

(LTR) later.

NOTE: Steps 88-92 pertains to vehicles with power

steering pumps. If your vehicle does not have a power

steering pump, disregard and proceed to Step 93. The oil

cooler must be moved up to clear the (LTR).

88. Unplug both horn connectors and remove horn

assembly using a 10mm socket. Make sure to identify the

driver side horn from the passenger side horn.