Owners manual

Part #1534, 1535

Brochure #63-1534

Rev. 6/2/15 - QT

Edelbrock E-Force Supercharger System

2011-’13 Dodge/Chrysler 5.7L and 6.4L Hemi

Installation Instructions

Page 21

95. Position the supplied low temperature radiator (LTR) in

front of the AC condenser. Lineup the mounting holes on

the LTR and A/C condenser. Secure the LTR and A/C

condenser to the radiator assembly with the factory bolts.

96. Reinstall the airbox shroud using the factory hardware.

97. Mount the intercooler reservoir to the supplied bracket

using the four M6 x 16mm bolts supplied in Bag #3.

98. Use a 13mm socket to remove the two inner nuts on

the passenger side strut tower. Secure the intercooler

reservoir assembly onto the strut tower studs and tighten.

Torque nuts to 20 ft/lbs.

99. Attach the Reservoir to Water Pump hose to the front

provision of the intercooler reservoir and secure it with a

hose clamp from Bag #3. Route the hose down to the inlet

of the water pump and secure it with a hose clamp.

100. Install the Manifold to Tank hose between the

supercharger and tank. Secure both ends of the hose with

hose clamps from Bag #3.

101. Connect the previously install Water Pump to LTR hose

to the LTR and secure with a hose clamp from Bag #3.

Apply six (6) inches of convolute sleeve to the LTR hose and

secure with electrical tape or equivalent.

Install 6” of Convolute