Owners manual

Part #1534, 1535

Brochure #63-1534

Rev. 6/2/15 - QT

Edelbrock E-Force Supercharger System

2011-’13 Dodge/Chrysler 5.7L and 6.4L Hemi

Installation Instructions

Page 25

NOTE: These supercharger systems are equipped

with adjustable boost settings. Level 3 being Mild,

2 Normal, 1 Aggressive/Race Only.

122. The supercharger is shipped from the factory with the

boost engagement level set to Level 2 (NORMAL boost

engagement level).

123. If you find that the boost engagement level is too

aggressive for normal street driving, set the boost

engagement level to Level 3/MILD by moving the spring into

position “3”. Level “1”/Aggressive, should only be used for

race and track applications. Make sure engine is cool

before making any adjustments.

124. The standard Edelbrock calibration is compatible will

all three (3) boost engagement level settings. No other

calibration is required if no other modifications are made to

the engine.

NOTE: Step 125 are for vehicles equipped with two piece

radiator shrouds. Disregard otherwise.

125. Test fit the radiator shrouds and trim as needed in

order to clear the intercooler and power steering cooler

hoses. Install radiator shrouds using the factory hardware.

Proceed to Step 130.

NOTE: Step 126-129 are for vehicles equipped with a front

fascia support. Disregard otherwise.

126. Remove both rubber strips from the front fascia

support.

127. Using a dremel or equivalent, grind down the lower tab

on the passenger side of the front fascia support.

128. Reinstall the front fascia support and the front bumper

absorber using the factory hardware.