Owners manual

©2015 Edelbrock LLC
Part #1534, 1535
Brochure #63-1534
Rev. 6/2/15 - QT
Edelbrock E-Force Supercharger System
2011-’13 Dodge/Chrysler 5.7L and 6.4L Hemi
Installation Instructions
Page 27
The Fuel Pump replacement procedure is only for 5.7L
vehicles. Disregard if your vehicle is not a 5.7L.
NOTE: Before beginning the installation of the supplied
fuel pump, make sure the fuel level of the vehicle is
below 5/8 of a tank to avoid fuel spillage in vehicle.
The fuel pump module must be installed in the same
position as removed. This step must be performed
correctly to prevent the float from contacting the side
of the fuel tank.
138. Install the supplied fuel pump by removing the rear
lower seat cushion. Push the rear lower seat cushion up
and back to remove.
139. Fold back the foam pad covering the fuel pump rubber
access plug. Remove the rubber access plug using a panel
tool and disconnect the electrical connector from the fuel
pump module.
NOTE: Prior to removing the fuel pump module, remove
any dirt or debris around the fuel tank opening with
compressed air or shop vac.
140. Position the lock ring remover/installer (Chrysler
#9340) or equivalent into the notches on the outside edge
of the lock ring. Attach a 1/2” drive breaker bar to the lock
ring remover/installer and rotate the breaker bar
counterclockwise to remove.
141. Lift the fuel pump module up to access the lower
power connections. Disconnect the connectors from under
the top of the fuel pump module and set aside.
142. Press the quick connect release tab on the fuel supply
line and remove. Now, disconnect the lower fuel pump
module electrical connector and fuel return lines.
143. Carefully turn the fuel pump module on its side to
drain the remaining fuel from the bottom reservoir and
remove from the vehicle.
NOTE: An alignment arrow is located on top of the fuel
pump module to help align it during installation.
144. Remove the rubber O-ring seal and discard. Replace
with the supplied rubber O-ring seal. Then lower the
supplied replacement fuel pump module into the fuel tank
and connect the fuel return lines.
145. Connect the fuel supply line and lower fuel pump
module electrical connector. Now connect the electrical
connectors at the top of the fuel pump module and lower
the fuel pump module into position.