Specifications

• GASKETS AND SEALANT
CAUTION: Do not use high performance or competition type intake gaskets for street application. Due to material deterioration under
street driving conditions, internal leakage of both vacuum and oil may occur.
1. Use only #7201 Edelbrock gasket set, Fel-Pro printoseal, or OE equivalent when installing Edelbrock manifolds for street
applications.
2. Apply Edelbrock Gasgacinch sealant, #9300, to both sides of the manifold as well as head surfaces. This procedure ensures a good
seal.
3. Eliminate the end seals. Use RTV Silicone sealant instead. Apply a bead of sealant approximately 1/4” high across the block end seal
surface, overlapping the intake gasket at the four corners. This method eliminates end seal slippage and deterioration.
4. For ease of installation, we recommend using Edelbrock Manifold Bolt & Washer Kit, #8504.
• MANIFOLD TORQUE—Torque all manifold bolts circled in Figure 1 to 25 ft/lbs. See Figure 1 for proper sequence.
• FIRING ORDER AND CYLINDER NUMBERING—For firing order and cylinder numbering, see Figure 2.
• FINAL TUNING FOR OPTIMUM PERFORMANCE
NOTE: Local emission laws must be checked for legality of any carburetor or ignition changes.
1. Due to design, the air/fuel mixture and cylinder charging are very efficient with the Performer RPM Q-Jet manifold. Generally speak-
ing, the stock jetting for the Performer RPM Q-Jet Series carburetor #1910 will not need changing. Some applications may show an
increase in power by re-calibrating the fuel metering circuits using jets, rods, hangars, and other parts available from Edelbrock.
2. Aftermarket distributor curve kits may be used with the Performer RPM Q-Jet manifold.
3. Use modified or high performance cylinder heads, and port-match the manifold to the heads. Edelbrock Performer RPM cylinder heads
#6071 or #6073 are fully assembled, ready to run cylinder heads that are designed to work with this intake manifold.
4. The compression ratio should be at least 9.5 to 1.
5. Installation of aftermarket headers, camshafts or both with an Edelbrock Performer manifold may lean carburetor calibration. Should
this condition occur, recalibrate your carburetor.
• CAMSHAFT AND HEADERS
The Performer RPM Q-Jet manifold is compatible with aftermarket camshafts and/or headers. Edelbrock has developed a dyno-
matched, street proven camshaft, the #7102 which is suitable for use with the Performer RPM Q-Jet manifold #7104.This camshaft
will require the use of high performance rocker arms, studs, retainers, and Edelbrock Sure-Seat valve springs #5703. Header primary
tube diameter should be 1-3/4”.
• PLEASE complete and mail your warranty card. Be sure to write the model number of this product in the “Part #____” space.
• THANK YOU
Figure 1—Intake Manifold Tightening Sequence
12
10
11
4
1
5
6
9
3
2
7
8
Figure 3—Remove shaded
area to provide clearance for
throttle or kick-down bracket
Figure 2—262-400 c.i.d. Chevrolet
Firing Order 1-8-4-3-6-5-7-2
Turn Distributor Counter
Clockwise to Advance Timing