Owners manual

Page 2
AUTOMATIC TRANSMISSION CHECK
For best performance, economy, and emissions, the transmission kick down and shift points must be checked before and after the Pro-
Flo 3 EFI installation.
SPARK PLUG WIRES
High EMI suppression spark plug wires are necessary, do not use solid core spark plug wires. Resistor type spark plugs are necessary.
EXHAUSTS SYSTEM
For best results, headers are recommended. For the Self Tuning function to properly operate, the exhaust system must be completely
sealed from header flange surface at cylinders heads to tailpipe. The exhaust system should be completely inspected prior to installing
the Pro-Flo 3 EFI system. All gaskets and hardware should be replaced. All hardware torques should be checked on regular bases.
CHARGING SYSTEM
The Pro-Flo 3 EFI System requires a constant battery voltage of 12.0 volts or greater to operate properly. Recommended battery
capabilities are: 1000Ca @32°F / 800Ca @0°F. The vehicle’s battery must be in good operating condition capable of maintaining a
proper charge at all times. Verify the vehicle’s charging system is operating properly and that the system voltage maintains 12.0 volts, or
greater, at all times. All chassis grounds must be tight and clean. A ground cable from the engine block to chassis should be employed.
All battery cables must be in good condition providing a clean tight connection to the battery.
COOLING SYSTEM
The minimum temperature requirement for the thermostat is 180°F.
TOOLS AND SYSTEM REQUIREMENTS
Use the following checklist for items needed.
 Wrench / Socket Set
 7/8” Oxygen Sensor Socket or Equivalent
 Pliers (channel locks and hose clamp)
 Screwdrivers (Phillips and Flathead)
 Gasket Scraper or Equivalent
 Timing light
 Shop Rags
 Edelbrock Gasgacinch #9300
 Loctite 598 OEM High Temperature Silicone Gasket (O2
Sensor Compatible)
 Vehicle Wiring Diagram (if available)
 Thread Sealer
 High-Heat Anti-Seize Compound
 180°F Thermostat
 Resistor Type Spark Plugs (Use correct heat range for your
particular application)
 High EMI Suppression Spark Plug Wires (DO NOT use solid
core spark plug wires)
 EFI Fuel System (See fuel system recommendation)
 Mechanical Fuel Pump Block Off Plate (Except for vehicles
running a Fuel Sump System #3605, 3606, 3607 & 36052)
 Fuel fittings (Additional fittings may be required depending on
routing preferences. Visit www.russell.com)
 30 AMP Automotive Relay (If using electric fans or A/C Kick up
- One relay required for each accessory)