Owners manual

Part Number 36031, 36032, 36033, 36034
Brochure #63-36031
©2017 Edelbrock LLC
Rev. 03/31/17 - NP
4
Edelbrock LLC • 2700 California St. • Torrance, CA 90503
Tech-Line: 800-416-8628
®
TWIST-LOC HOSE ASSEMBLY
1. Protect the Twist-Loc fitting finish by wrapping the hex
with painters tape or equivalent and secure the fitting in
a vice as shown below.
2. Lubricate the barbed end on the fitting with silicone lube
as well as the inside of the hose end that will mate with
the fitting.
3. Use a heat gun to heat the end of the hose that will mate
to the fitting. Rotate the hose slowly to make sure that
the hose is heated evenly. Be careful not to overheat or
burn the hose. If light smoke is visible, stop heating the
hose and proceed to step #4.
WARNING! DO NOT GRAB THE HOSE BY THE HEATED END
FOR ANY REASON.
4. While the hose end is hot, push the hose onto the fit-
ting using one, quick motion to fully seat the hose on
the fitting so it reaches over both fitting barbs. If the
hose is fully seated on the fitting, proceed to step #6.
5. If the hose is not able to be pressed onto the fitting,
repeat step #3 and try again. If the hose is only able
to be partially installed on the fitting, remove the hose
by cutting it with a razor blade parallel to the fitting.
Trim the hose end to remove the cut left by the razor
blade and go back to step #3.
6. Allow the new assembly to cool before proceeding to
the next step in the main instruction sheet.