Instructions / Assembly

STEP O NE

Layout the horizontal bottom rail and insert the two long vertical

spindles followed by seven of the middle rails. The spacing should be

roughly 5 1/2” apart. Subsequently, place the curved rail over the two

long vertical spindles as shown aside.

Set out one post and snap side panel into place starting with the

curved top rail.

Lay out the second post with holes facing upwards and insert

the completed panel and connected post. Please note the locations

of the screw holes to ensure proper installation.

With 3” screws provided, secure bottom and top rails into the post

through the pre-drilled holes as shown aside.

Slide the post trim cap over each of the posts. Allow the post trims to

slide down the post as they will be loose at this point.

Glue and attach the post cap insert over the posts as shown.

The Westhaven Arbor

Assemble the Side Panels