Installation Guide

ManualsBrandsEden Bath ManualsPlumbingEB_S002DE-P Dark Emperador Vessel Sink Bowl

Large Nut Type Installation

The following installation guide and its associated photos are merely an informative example of how the faucet is installed and may not be an exact representation

of the faucet you are installing. We recommend that installation should only be completed by a trained plumber. Eden Bath, its dealers, and affiliates take no re-

sponsibility for the information provided below and will not be liable for any misuse or damages caused by using this information.

1. Ensure the water in your home

is turned off. Attach both hold and

cold steel braided water supply

lines provided, to their respective

threaded connectors at the bot-

tom of the faucet. Hot: Left - Cold:

Right.

2. Tighten both supply lines by

hand, and then with a wrench or

grips, but be careful not to over

tighten or you may strip or crack

the threaded connectors.

3. Attach the threaded pipe to the

bottom of the faucet if it isn't al-

ready attached. Remove the

large nut and matching rubber

gasket. Insert the water supply

lines and faucet into the mounting

hole in your countertop.

4. Attach the nut sized rubber

gasket, then the large nut pro-

vided to the threaded pipe from

underneath the countertop and

tighten with a wrench or grips

until the faucet is secured.

5. Apply plumbers tape / Teflon

tape to the threaded connectors

of your homes supply pipes. At-

tach the steel braided water sup-

ply lines from the faucet, to each

of the hot and cold supply valves/

connectors and tighten.

All Eden Bath products are covered under a 1 year limited warranty against manufacturing defects.

Faucet Installation Guide

If your faucet includes the above mounting hard-

ware, please follow the set of instructions to the

right. This threaded pipe and nut may be attached to

the bottom of your faucet already.

Screw And Horseshoe Plate Type Installation

1. Ensure the water in your home

is turned off. Attach both hold and

cold steel braided water supply

lines provided, to their respective

threaded connectors at the bot-

tom of the faucet. Hot: Left - Cold:

Right.

2. Tighten both supply lines by

hand, and then with a wrench or

grips, but be careful not to over

tighten or you may strip or crack

the threaded connectors.

3. If a thin circular rubber ring

was provided, place it between

the faucet and the top of the

countertop. Insert the water sup-

ply lines and faucet into the

mounting hole in your countertop.

4. Place the horseshoe shaped

rubber gasket and metal plate

under the countertop with the

supply lines coming through the

open area. Attach provided

screws through plate holes and

into the faucet body and tighten.

5. Attach the nuts provided to the

threaded screw shaft and hand

tighten until flush with the metal

plate. Then do a final tightening

with a wrench or grips until the

faucet is secure.