Owner's manual

8
Post Tone Effects Loop
This loop is set up after the tone controls and just before the power
amplifier input. It breaks the circuit between the preamplifier and the
power amplifier when in operation.
Pre Tone Effects Loop
This loop is before the tone controls. The send can be used as an extra
signal output without breaking the loop. This loop is a good choice for
outboard compressors and limiters.
Tuner Output
This gives you a place to connect your tuner out of the direct signal path
of the Bass. It is always on. Even when the mute is engaged the output
stays connected.
For Your Safety
Always use a correctly grounded outlet for your amplifier. Replace your
fuse with only the same size and type of fuse. Your unit has a two year
warranty described in the warranty section of your manual.
If you have questions about the operation of your unit or have any
service needs please contact us @ Nemesis service 1-612-675-3579 or
612-675-3650 and ask for the Nemesis Service Dept.
CR Eden Electronics Inc. Montrose, MN 55363