WT-1000 Users Manual High Power Bass Guitar Amplifier Revised 3-28-03
Congratulations on your purchase of the Eden WT-1000 Bass Instrument Amplifier. You have purchased what we feel is one of the finest bass amplifiers in the world. The WT-1000 produces 450 watts of pure power into 4 ohms (240 watts into 8 ohms) with min. 3db of dynamic headroom. This compact, rack mountable package houses modular circuits made with superior components and designed for years of trouble-free service. Thank you for choosing Eden.
General Specifications Size 3.5” x 19” x 14” Weight 28 Lbs. EIA rack 2 Space w/ min. clearance Power Output @ 8 ohm x 2 240 Watts RMS Headroom +3dB min. Damping Factor better than 100 from 20Hz to 1Khz Slew Rate 128V/8us Rise time 11us Frequency Response 13Hz to 36KHz +/- 3dB Distortion THD .06 % Power Requirements The WT-1000 needs a separate properly grounded 20 Amp circuit @ 120 Volts for correct operation and best sound quality. FOR YOUR SAFETY DO NOT REMOVE OR MODIFEY THE GROUND ON YOUR POWER CABLE.
Volume Control This control sets the level of signal going to the amplifier output stage. The further the control is turned to the right the less signal is required to drive the amplifier to full output. Tone Balance control The tone balance allows the player to adjust the entire audio spectrum with one simple control. The tone balance is a teeter totter type control. When the Bass is turned up the level goes up in the bass ,shifts back to neutral across the midrange and shifts lower in the treble ranges.
Channel Output Indicator This LED indicates that the amplifier channel has reached maximum output and is going into limiting. On / Off Switch This turns the unit on and off . Front Panel Air Intake Do not obstruct the airflow to this intake. Back Panel Features Inputs ( Balanced & Unbalanced) The inputs are configured as a Balanced/unbalanced TRS ( Tip, ring, sleeve ¼” jack ) and a 3 pin XLR balanced Mic. Connector. These are wired in parallel without buffers.
AC Inlet and Fuse Holder Your unit is fitted with an IEC interface for universal AC cable connection. The fuse is selected for the country of operation (see list at front of manual). Replace the fuse ONLY with the same type and size as the original. Airflow Exit Do Not Block This Exit. If the airflow exit becomes obstructed the amplifier will over heat and go into thermal limiting. The unit should be cleaned and serviced about once a year by a qualified technician.
