WT-390 Time Traveler Bass Guitar Amplifier SIGNATURE SERIES Owner’s Manual 12/20/04 1
Foreword Congratulations on your purchase of the Eden Time Traveler Bass Instrument Amplifier. You have purchased what we feel is one of the finest bass amplifiers in the world. The Time Traveler produces 330 watts of pure power into 4 ohms (180 watts into 8 ohms) with 3db of dynamic headroom. The new pre-amp. Section, with its familiar Eden enhance control, and powerful new 3 way tone control system are coupled to a studio quality compressor.
Label1 FRONT PANEL FEATURES Input Jacks – Designed to accept a simultaneously boosts the very low bass, upper middle, and high frequencies while putting a dip in the lower middle frequencies. It is flat when set to its minimum level. standard ¼ inch mono phone plug. For best results use a high-quality shielded cable to connect your instrument to the amplifier. Both inputs are buffered and will handle standard, high level and piezo input signals.
indicates that the amplifier has reached its maximum output level. Mains On/Off Switch – This switch turns the system power on or off. The switch illuminates to indicate the presence of AC power present in the chassis. This switch is prior to the fuse. The switch light can be on even if the fuse is blown The light in the switch may flicker depending on local voltage conditions. This is normal and nothing to be concerned about Speaker On/Off Switch- This switch turns off the loudspeaker out put jacks .
normally even when the amplifier is in thermal shut down. Only the stage sound will be lost.) OPERATING INSTRUCTIONS MECHANICAL AND THERMAL ISSUES – Your amplifier should always be placed for operation away from sources of moisture or heat. Care should be taken not to obstruct the ventilation holes on the bottom and sides of the unit. In the event of thermal shutdown, you should eliminate the cause of the thermal problem (poor ventilation, speaker loads lower than 4 ohms) immediately.
panel diagrams at the back of this manual to help you record your settings. Clip Light – This indicator will flash if clipping occurs in the EQ section of the preamp. This can be remedied by decreasing the amount of boost in the EQ section or by decreasing the Gain control. This light should never be on while playing. Other EQ Considerations – If you find yourself running out of amplifier headroom, cut a little in the lower frequencies, which require the most power from your amp.
and sides of the unit to ensure that they have not become blocked by accumulated dust. Vacuum the openings to remove any dust buildup. Service – In the event of amplifier malfunction, or questions about your unit’s operating features, you should contact your Dealer. For more information or to obtain a Return Authorization number and instructions for factory returns, please contact our customer service dept. (847) 949-0444 (847) 949-8444(fax) CR Eden Div. US Music 444 Courtland Rd.
