Eden Electronics Operation Manual World Tour Series Amplifier WT-400 Bass Amplifier LN Traveler Plus Owner’s Manual Revised 2/06/03 1
WT-400 Operations Manual Congratulations on your purchase of the Eden WT-400 Traveler Bass Instrument Amplifier. You have purchased what we feel is one of the finest bass amplifiers in the world. The WT-400 produces 400 watts of pure power into 4 ohms (235 watts into 8 ohms) with 3db of dynamic headroom. The tube preamp section, with its enhance control, powerful quasiparametric tone control system, and gentle auto-compression circuit allow you to achieve a wide array of sounds.
FRONT PANEL FEATURES Frequency control – Provided for low, Input Jack – Designed to accept a mid, and high frequency ranges, these controls select the frequencies you wish to boost or cut. standard ¼ inch mono phone plug. For best results, use a high-quality, shielded cable to connect your instrument to the amplifier. Input Pad – By pulling the Gain control knob out, you engage a –12db pad, which will prevent the system from being overdriven by high-output instruments.
REAR PANEL FEATURES Combination Power Cord Jack and Fuse Holder – The removable power cord is attached here. Pulling the holder out of the top of the power inlet accesses the fuse carrier. Your unit was shipped with a spare fuse inserted in the fuse carrier. USE ONLY THE SAME SIZE AND TYPE FOR REPLACMENT. U.S. users should make sure the fuse holder is installed so the “115 VOLTS” reads right side up. For Europe the 230 should be right side up.
made with high-quality shielded cables. The use of speaker cables for line connections will result in excess noise. Speaker connections should be made with highquality 16 gauge or larger unshielded speaker cables. We recommend 10 or 12 gauge cables. The use of shielded line or instrument cables for speaker connections can damage your amplifier. The speaker cable should be as short as possible. TURN ON – We recommend turning your system on with the master volume control set to its minimum position.
Other EQ Considerations – If you find (1) D115XL & (1) D210T 8 Ohm cabinet yourself running out of amplifier headroom, cut a little in the lower frequencies, which require the most power from your amp. Headphone Jack as Line Driver – On Two areas are a frequent source of frustration for bassists trying to achieve their sound: frequency masking and frequency enhancement.
Tube Replacement – Tube life varies Service – In the event of amplifier greatly depending upon use, vibration, and tube quality. It is uncommon for a tube to last less than a year in our circuits. Tube life of several years is not at all uncommon. Symptoms of tube failure include signal loss, distortion, and increased noise. The tube is easily replaced by removing the unit’s cover. Always disconnect the power cord from the back of the unit prior to removing the cover.
EQ Settings Setting name: _____________________ Setting name :___________________ Setting name: _____________________ Record your Favorite Tone settings 8
