Installation guide

C HAPTER 3 | Using the Web Interface
Navigating the Web Browser Interface
– 34 –
VLAN Stacking
S-VLAN Table Sets QinQ settings for the switch 62
S-VLAN Setting Sets QinQ settings for ports 63
IGMP Snooping
Multicast Entry Table Displays multicast groups to be filtered for VLANs 66
IGMP Snooping Setting Configures global and port settings for multicast filtering 67
Spanning Tree
STP Global Setting Configures global bridge settings for RSTP 72
STP Port Setting Configures individual port settings for RSTP 75
QoS
Port-based Priority Configures the default CoS traffic class for ports 80
DSCP-based Priority Maps DSCP values to standard CoS classes 81
Priority to Queue
Mapping
Configures CoS traffic class to port queue mapping 82
Packet Scheduling Configures port queue mode and queue weights 84
LLDP
LLDP-Setting Configures global and port LLDP settings 87
LLDP Neighbors Displays LLDP information about a remote device
connected to ports on this switch
89
SNMP Configures read-only and read/write community strings
for SNMP v1/v2c, engine ID for SNMP v3, and trap
parameters
91
Port Mirroring Sets source and target ports for mirroring 95
Port Security Configures source MAC address limits for ports 97
Bandwidth Control Configures ingress and egress rate limits 99
Jumbo Frame Enables Jumbo Frame support 101
Management Access Filter Sets IP addresses of clients allowed management access 103
Security
MAC Address
MAC Forwarding Table Displays dynamic and static addresses 105
Static MAC Configures static MAC addresses 106
MAC Filtering Sets source and destination MAC address filters 107
802.1x
802.1x Setting Configures global 802.1X settings 110
802.1x Port Setting Configures 802.1X settings for ports 111
IP Filter Setting Filters traffic based IP addresses 113
Storm Control Sets limits for broadcast, multicast, and unknown
unicast traffic
114
Table 4: Main Menu
Menu Description Page