Installation guide

3-6
Installing the Switch
3
Connecting to a Power Source
First verify that the external AC power supply can provide 100 to 240 VAC,
50-60 Hz, 8 A minimum.
Note: For international use, you may need to change the AC line cord. You must use a
line cord set that has been approved for the receptacle type in your country.
To connect a device to a power source:
1. Insert the power cable plug directly into the socket located at the back of the
device.
Figure 3-6 Power Receptacle
2. Plug the other end of the cable into a grounded, 3-pin socket.
3. Check the front-panel LEDs as the device is powered on to be sure the System
LED is on. If not, check that the power cable is correctly plugged in.