Owner manual

SAVE THESE INSTRUCTIONS!
M2C-LC-_
- This product is ETL listed for indoor dry locations.
- This product joins and electrically conducts two Monorail 2
Circuit sections end to end at 90° angle for ceiling
installation.
- The product is intended to be used with Edge Lighting
Monorail 2 Circuit systems only.
Installation Instructions for
Connector
Monorail 2 Circuit Ceiling "L" Conductive
1
904-M2C-LC-02
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: [phone]
Fax: [phone]
www.edgelighting.com
[e-mail]
A
Install the Monorail 2 Circuit Ceiling "L" Connector
1: Push the Monorail 2 Circuit ceiling "L" connector pins
completely into one Monorail 2 Circuit section. Make sure
this Monorail section is secured with the standoffs
(Refer to the instructions provided with the
standoffs).
B
2: Push the other Monorail section completely onto the
Monorail 2 Circuit ceiling "L" connector pins and
simultaneously connect the Monorail 2 Circuit to the
standoffs.
ONE MONORAIL 2
CIRCUIT SECTION
MONORAIL 2 CIRCUIT
"L" CONNECTOR
THE OTHER
MONORAIL
2 CIRCUIT
SECTION
1
2
2
© 2009 Edge Lighting. All Rights Reserved.