Instruction Manual

SAVE THESE INSTRUCTIONS!
M2-_R-_
- This product is ETL listed for indoor dry locations.
- Monorail 2 Circuit is bendable horizontally to a radius as
small as 6".
- The product is intended to be used with Edge Lighting
Monorail 2 Circuit systems only.
Pre-Bent Monorail 2 Circuit
Installation Instructions for
904-M2-RCS-02
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: [phone]
Fax: [phone]
www.edgelighting.com
[e-mail]
M2-_C-_
M2-92S-_
1: Push the Monorail 2 Circuit conductive connector pins
completely into one pre-bent Monorail 2 Circuit section.
Make sure this Monorail 2 Circuit section is secured
with the standoffs (Refer to the instructions provided
with the standoffs).
2: Push the other pre-bent Monorail 2 Circuit section
completely onto the Monorail 2 Circuit straight conductive
connector pins and simultaneously connect the pre-bent
Monorail 2 Circuit to the standoffs.
ONE PRE-BENT MONORAIL
2 CIRCUIT SECTION
STRAIGHT
CONDUCTIVE
CONNECTORS
A
1
Connect the Pre-Bent Monorail 2 Circuit Sections with the
Conductive Connectors
Connect the Pre-Bent Monorail
2 Circuit section with the
Isolating Connectors
2
B
ISOLATING CONNECTOR
ONE PRE-BENT MONORAIL 2 CIRCUIT SECTION
1
1: Push the straight isolating connectors completely into one
pre-bent Monorail 2 Circuit section end. Make sure this
pre-bent Monorail 2 Circuit section is secured with
the standoffs (Refer to the instructions provided with
the standoffs).
1
2
© 2009 Edge Lighting. All Rights Reserved.