Owner's manual

4
CAP
3/8-24 SETSCREW
POWER HOUSING
1
2
MIDDLE
CONTACT
KNURLED
NUT
3
1: Unscrew the cap from the power housing.
2: Slightly loosen the 3/8-24 set screw on the cap with the
3/16 Allen wrench provided, DO NOT REMOVE IT.
3: Slightly loosen the knurled nut on the power housing so that
the middle contact moves back and clears the power housing
opening.
J
Install the Monorail 2 Circuit to the Transformer
K
CAP
POWER HOUSING
MONORAIL 2 CIRCUIT
L
CAP
6: Tighten the 3/8-24 set screw on the cap with the 3/16
Allen wrench for proper power connection.
7: Tighten the knurled nut for proper power connection.
7
KNURLED NUT
3/8-24 SET SCREW
3/16 ALLEN WRENCH
6
NOTE:
the Monorail 2 circuit while connecting Monorail 2 circuit to the
surface mount transformer (refer to the instructions provided with
the standoffs).
The proper size standoffs should be installed to support
4: Place the into the power housing and
support it with the standoffs (refer to the instructions
provided with the standoffs).
5: Tighten the cap to the power housing. Make sure the cap
is not cross threaded.
Monorail 2 Circuit
4
4
5
SWITCH 1
M
SWITCH 2
HOT 1
HOT 2
COM
HOT 1
COM
NOTE:
Switch 2 turns on/off circuit 2 (COM & HOT 2). Load each circuit of
Monorail 2 Circuit to MAXIMUM 150 watt.
Switch 1 turns on/off the circuit 1 (COM & HOT 1) and
HOT 2
MONORAIL 2 CIRCUIT