User Manual

Evolution FORD 4.6 and 5.4 Liter

Getting Connected

The Evolution programmer connects to the diagnostic port of your vehicle.

Follow these steps to install the Evolution:

1. Begin by turning your ignition key to the OFF position. Locate the

black diagnostic (OBDII) connector (Figure #1) under the dash near

the steering column. As you sit in your vehicle, it could be located

right above your right knee. Sometimes the cover to this connector will

be labeled “Data Link.” Feed the cable up towards the top of the

dashboard, but do not plug into the OBDII connector yet.

Figure #1

2. With the driver’s side door open, remove the access panel on the left

side of the dashboard (Figure #2) and pull the end of the ODBII cable

outwards (shown in Figure #3). Snake it up to the A-pillar of the

vehicle and replace the access panel. The cable should be protruding

from the dashboard up along the A-pillar and be able to move freely

when pulled.