Instructions / Assembly

+1 (877) 796 2263

EDGERIGHT.COM

INFO@EDGERIGHT.COM

INSTALLATION TIPS:

Sharp Bends

Place the block across the valley of the

teeth, bend material to the desired angle

while applying pressure to the block.

Gradual Bends

Stand the material on end and apply

pressure to the middle in order to ex the

material to the desired radius.

BENDING

You can accommodate for slight hills or

elevations changes by gaping the material

at the joint and using the connector to

cover the space.

ELEVATION CHANGES

Instead of cutting, overlapping the material is

easiest to achieve the desired length. Our con-

nectors are designed to cover 1 or 2 pieces of

edging.

Always point teeth away from you.

OVERLAPPING

PAGE 1
INSTALLATION TIPS: BENDING ELEVATION CHANGES OVERLAPPING Place the block across the valley of the teeth, bend material to the desired angle while applying pressure to the block. You can accommodate for slight hills or elevations changes by gaping the material at the joint and using the connector to cover the space. Instead of cutting, overlapping the material is easiest to achieve the desired length. Our connectors are designed to cover 1 or 2 pieces of edging. Always point teeth away from you.
PAGE 2
1 2 WHAT YOU’LL NEED • Wood Block • Hammer • Knee Pads • Gloves • Safety Glasses STEP 1 Use an edger or shovel to help loosen the soil and define the path where edging will be installed. TIPS • Wetting the ground can make installation easier in hard soils. • Position block with grain across the edging. This will minimize cracking while hammering. • Alternating strikes on both ends will encourage even installation.