Edge GM Juice Supplement Installation Instructions READ IMPORTANT SAFETY INFORMATION IN THIS MANUAL
Edge Products ______________________________________GM Juice-Attitude CS/CTS Table of Contents IMPORTANT SAFETY INFORMATION _____________________________________ 3 SAFETY TERMS _____________________________________________________________ 3 SAFETY GUIDELINES _______________________________________________________ 3 PRODUCT REGISTRATION _______________________________________________ 4 Benefits of product registration: _________________________________________________ 4 About the Edge Juice ______________
Edge Products ______________________________________GM Juice-Attitude CS/CTS IMPORTANT SAFETY INFORMATION SAFETY TERMS Throughout this User Guide (hereafter referred to as User Manual or Manual) you will see important messages regarding your safety or the protection of your vehicle. These messages will be designated by the words WARNING or CAUTION. WARNING indicates a condition that may cause serious injury or death to you, your passengers or others nearby.
Edge Products ______________________________________GM Juice-Attitude CS/CTS 6. Do not use the Performance Tests feature to break any traffic laws. Perform these tests only where they are legal and safe. 7. Some features may not function on all vehicle models. Check a newly-installed device for all features you intend to use. Do not rely on their working without checking first. NOTE: Dispose of this product consistent with local codes. Return to your electronics supplier for proper handling.
Edge Products ______________________________________GM Juice-Attitude CS/CTS If you have used another tuner/programmer on your vehicle, you will need to program back to stock and remove the device before using the Edge Products Device. Failure to return to stock may result in PCM failure or engine damage. Note: This manual includes installation instructions to install the Juice module in various GM model years and is designed to be used with the CS/CTS Attitude monitor. 1. Refer to your model Year section.
Edge Products ______________________________________GM Juice-Attitude CS/CTS Power Levels Power level 1 is specifically designed to maximize fuel economy improvements. We recommend level 1 or level 2 for towing applications. Use level 2 when towing a load. Power levels are changed using the CS/CTS Attitude monitor. WARNING Do not exceed your vehicle’s max GVWR as outlined in the vehicle’s owner’s manual. Doing so may result in loss of vehicle control and cause bodily injury.
Edge Products ______________________________________GM Juice-Attitude CS/CTS In our experience 1350 degrees is about as high as you want to let your EGTs go. Keep in mind, the stress on your engine created by the heat is a function of both temperature and time. A brief spike to 1400 that lasts a second is not that big a deal. Pulling up a hill for several minutes at 1400 is far worse. As you drive your vehicle in the various power settings, keep your eye on the EGTs.
Edge Products ______________________________________GM Juice-Attitude CS/CTS Supplied Items: 1. Edge Juice Module 2. Harness cable set 3. Depending on your vehicle year, the accessory package will include Velcro mounting strips, wire ties and leaded fuse links. 4. EGT Thermocouple Sensor Probe Required Tools: 1. 2. 3. 4.
Edge Products ______________________________________GM Juice-Attitude CS/CTS Carefully insert the Juice "T" harness connectors between the mating stock engine harness connectors and lock in place with the gray levers.
Edge Products ______________________________________GM Juice-Attitude CS/CTS 2006-2007 GMC Duramax 6.6L LLY & LBZ The following picture shows the Edge Power Juice Module with the harness cable. Note: If you have a Harness with (2) “T” connectors, the 2nd T is necessary and should be used with both “T’s” installed. These two connectors are used to connect the EGT.
Edge Products ______________________________________GM Juice-Attitude CS/CTS 2. Route the turbo timer wire with the red female connector end into the side of the fuse box to connect the turbo timer. 3. Locate and remove the 10 amp “TBC BATT” from inside the engine compartment fuse panel. 4. Insert the Leaded Fuse Link (see figure 11). The leg with the wire soldered to it needs to plug into the “HOT” side of the fuse location. Orient the fuse exactly as shown in fuse box picture below. 5.
Edge Products ______________________________________GM Juice-Attitude CS/CTS Power Gains (2006-2007 GMC Duramax LLY & LBZ) Level Horsepower Torque LEVEL 0 0 0 LEVEL 1 30 60 LEVEL 2 40 80 LEVEL 3 50 90 LEVEL 4 60 100 LEVEL 5 80 130 LEVEL 6 (See Hot Unlock section) 100 200 2007.5-2010 GMC Duramax LMM The following picture shows the Edge Power Juice Module with the harness cable. This cable is where the Edge CS/CTS Attitude cable gets connects.
Edge Products ______________________________________GM Juice-Attitude CS/CTS Carefully insert the Juice “T” connectors and lock in place with the blue levers, and then gently connect the stock connectors to the other end of the Juice connectors. Lock the blue levers, by sliding the green tab back into original lock position. (see following picture for finished connection) 2. Route the green/yellow turbo timer wire with the red female connector end into the side of the fuse box to connect the turbo timer.
Edge Products ______________________________________GM Juice-Attitude CS/CTS “HOT” side of the fuse location. Orient the fuses exactly as shown in fuse box picture below. Note: The Turbo timer will not function unless the vehicle has the Attitude CS/CTS monitor installed. WIRE LEADED FUSE LINK 5. Connect the green turbo timer wire to the “IPC” (Fuse 43) fuse link. Connect the yellow turbo timer wire to the “MISC IGN” (Fuse 40) fuse link.
Edge Products ______________________________________GM Juice-Attitude CS/CTS Power Gains (2007.5-2010 GMC Duramax LMM) Level Horsepower Torque LEVEL 0 0 0 LEVEL 1 30 60 LEVEL 2 40 80 LEVEL 3 50 90 LEVEL 4 60 100 LEVEL 5 80 130 LEVEL 6 (See Hot Unlock section) 85 200 Final Inspection Recheck all connections for a properly secure installation. Using the supplied wire ties, secure the wiring harness to prevent possible damage. Start the engine.
Edge Products ______________________________________GM Juice-Attitude CS/CTS 1. Obtain a 1/8” tapered National Pipe Tap (NPT) available from your hardware store. Drill a 21/64” (5/16” optional) hole through the manifold wall, and then use the pipe tap to cut the threads. Follow the instructions provided with the tap. The pipe tap is tapered, so you will only want to turn the tap until the bottom threads of the tap are slightly deeper than flush with the inside of the exhaust manifold wall.
Edge Products ______________________________________GM Juice-Attitude CS/CTS Correct Incorrect Tip: Pulling back the wheel splash guard may provide easy access to the exhaust manifold for tapping the EGT cable. 2001-2005 GM Duramax 6.6L LB7 & LLY 17 The EGT thermocouple installed into the drilled and tapped exhaust manifold.
Edge Products ______________________________________GM Juice-Attitude CS/CTS The EGT thermocouple installed into the drilled and tapped hole in the exhaust manifold. 2007.5-2010 GM Duramax 6.6L LMM 3. With the Thermocouple installed and the cable routed to the top of the engine compartment, connect the (2) ring terminals to the mating Juice harness terminals with the supplied hardware. Position the supplied shrink wrap first and then secure the fasteners after mating to the color coded wires.
Edge Products ______________________________________GM Juice-Attitude CS/CTS Attach the EAS JAB (Juice-Attitude Bridge) The JAB is part of the EAS (Edge Expandable Accessory System). It can be used with an EAS EGT if you have one installed. The expandable Accessory system allows starting with one sensor and adding more as needed. The components connect to each other using keyed guide slots and locking nuts on each accessory.
Edge Products ______________________________________GM Juice-Attitude CS/CTS EAS Cable and Terminator Cap attached to the EAS JAB sensor T. EAS Cable JAB Sensor T Terminator Cap 2. Hang the EAS JAB connector assembly as shown, using the supplied Nylon ties. JAB Sensor T tied to a flange at top of drivers side firewall. Coil and support extra cable/wire by tying to the firewall. 3.
Edge Products ______________________________________GM Juice-Attitude CS/CTS Note: If the Juice module had previously been installed with the 3- position power level switch or another Edge device, the switch cable will have to be disconnected or removed to allow the CS/CTS Attitude cable to be installed. Carefully lift the latch on the Juice connector side to allow the connector to release. Juice Attitude Connector EAS JAB Connector Lift latch to disconnect 4.
Edge Products ______________________________________GM Juice-Attitude CS/CTS 5. Run the cable up under the dash. Open the driver’s side door, and remove the access panel on the left side of the dashboard. (The panel will typically unsnap when the bottom is pulled out.) Remove fasteners if required, and route the cable behind the panel and up to the A-pillar. Replace the screws, and access panel. The cable will protrude from the dashboard up along the A-pillar and be able to move freely when pulled.
Edge Products ______________________________________GM Juice-Attitude CS/CTS 6. With roughly 8 to 10 inches of the EGT cable extending above the dashboard, plug the 6-pin connector into the accessory port on the back of the CS/CTS device. Insert 6-pin EAS cable connector into the 6pin port on the back of the CS/CTS device. 7. With the cable connected turn the ignition key ON and touch the screen. Verify readings display on the CS/CTS Device.
Edge Products ______________________________________GM Juice-Attitude CS/CTS Hot Unlock Code The Juice module is equipped with an optional level 6. This level is a high performance level, and should be used only when proper power and drive-train upgrades have been made. After installing the device the following Race Unlock code screen will display. Record the Serial Number and have it available when you go to the website link. The Serial Number of your product is found at the top of the screen.
Edge Products ______________________________________GM Juice-Attitude CS/CTS 1. For the CS, enter the Unlock Code by using the buttons. Press the Up or Down Arrow and [ENTER] alternately until the last digit of code is entered. Then press [ENTER] 2. For the CTS, enter the Unlock Code by using the alpha-numeric touch pad on the screen. Enter the code in sequence until the last digit is entered. 3. After the last digit of the code is entered, the following screen will appear.
Edge Products ______________________________________GM Juice-Attitude CS/CTS Warranty Information LIMITED 1 YEAR WARRANTY Edge Products, LLC, (hereafter "SELLER") gives Limited Warranty as to description, quality, merchantability, fitness for any product’s purpose, productiveness, or any other matter of SELLER's product sold herewith. The SELLER shall be in no way responsible for the product’s open use and service and the BUYER hereby waives all rights other than those expressly written herein.
Edge Products ______________________________________GM Juice-Attitude CS/CTS product that can be easily removed. NOTE: Even if you disconnect your unit, your dealer can detect the use of any programmer—even if the unit has been removed. Thank you for purchasing the Edge Juice Module and Attitude Monitor for the Dodge Cummins® Diesel. The Juice and Attitude have been developed and produced from the highest quality materials available to ensure the best performance for years to come.
Edge Products ______________________________________GM Juice-Attitude CS/CTS Glossary of Terms Backdown – This is decreasing the amount of additional fueling. % Backdown is the percentage of additional fuel held back. The Juice/Attitude includes a feature to backdown the fueling to control critical parameters such as EGT and Boost. Barometric pressure – This is a measurement of the atmospheric pressure, mainly due to your altitude (above or below sea level) and the current weather conditions.