E ACTIV www.edgecaraudio.
INTRODUCTION This instruction manual is for your safety and must be adhered to at all times. Please read and ensure that you fully understand the installation and set up procedures as explained. If you are unclear on the installation or set up of your EDGE speakers please contact your nearest authorised EDGE dealer. Contents EDGE enclosure Wiring kit Manual Warranty card Sticker WARNING DO NOT EXPOSE THIS PRODUCT TO DAMP OR MOISTURE - doing so may result in fire, shock or damage to the product.
20A The most common place to mount a bass enclosure is in the luggage compartment of the vehicle. Where in the luggage compartment it is mounted will have an effect on the sound produced allowing the user to tailor the sound to best suit their musical tastes. For example if the enclosure is mounted facing the rear bumper, the bass produced will be noticeably deeper than if it is fired into the rear seat.
ED7200-E1 (75 watts use on EDB12A, EDB10A only) CONNECTIONS & CONTROLS ED7300 ED7200-E1 ED7200-E1 (75 watts use on EDB12A, EDB10A only) ED7300-E1 ED7300-E1 (125 watts use on EDB12TA only 20A ED7300-E1 lifie r ED7200-E1 ier r k am plif lifie oblo ab m on 00 cla ss ED73 ED73 00 cla ss ck a mp lifie r ab m ono bloc amp ab m ono bloc k 00 cla ss ED72 00 cla ss ab m ono b lock amp 20A ED72 ED7200 ED7300-E1 (125 watts use on EDB12TA only)
1. Fuse Remote Turn On 5. Bass boost ED7200: ensure a 20 amp fuse is fitted, never fit a fuse with a rating higher than 20 amps. ED7300: ensure a 25 amp fuse is fitted, never fit a fuse with a rating higher than 25 amps. A minimum of 18 gauge cable should be used for this connection. The cable should be run with exactly the same care and attention as the power cable and taken back to the source and joined to the remote cable provided on the head unit.
Set Up Section Gain Control Setting To correctly set the gain control of the amplifier to match that of the source (headunit) use the following setup routine: ● Turn the gain control to minimum on the amplifier. ● On the headunit set all crossovers to flat and both bass and treble to zero. ● Turn up the source (headunit) to approx 3/4 volume.
NOTES