MSDS

Page 2 of 7
Ingredient
CAS Number
% by Wt.
Inorganic compounds of Lead
7439-92-1
75-77
Electrolyte (no fluid/completely absorbed)
sulfuric acid/water/solution
7664-93-9
14-16
Case Material:
Polypropylene
9003-07-0
9003-07-0
Separator:
N/A
1-3
Note:
Inorganic lead and electrolyte (water and sulfuric acid solution) are the primary components of every battery manufactured by Exide
Technologies or its subsidiaries. Other ingredients may be present dependent upon battery type. Polypropylene is the principal case
material of automotive and commercial batteries.
IV. FIRST AID MEASURES
Take proper precautions to ensure you own health and safety before attempting to rescue a victim and provide first aid.
Inhalation: Electrolyte: Remove to fresh air immediately. If breathing is difficult, give oxygen.
Lead compounds: Remove from exposure, gargle, wash nose and lips; consult physician.
Skin Contact: Electrolyte: Flush with large amounts of water for at least 15 minutes; remove contaminated clothing completely,
including shoes.
Lead compounds: Wash immediately with soap and water.
Eye Contact: Electrolyte and Lead compounds: Flush immediately with large amounts of water for at least 15 minutes; consult
. physician immediately
Ingestion: Electrolyte: Give large quantities of water; do not induce vomiting; consult physician.
Lead compounds: Consult physician immediately.
V. FIRE FIGHTING MEASURES
Flash Point: Not Applicable
Flammable Limits: LEL = 4.1% (hydrogen gas in air) ; UEL = 74.2%
Extinguishing media: CO
2
; foam; dry chemical
Fire Fighting Procedures:
Use positive pressure, self-contained breathing apparatus. Beware of acid splatter during water application and wear acid-resistant
clothing, gloves, face and eye protection. If batteries are on charge, shut off power to the charging equipment, but, note that strings
of series connected batteries may still pose risk of electric shock even when charging equipment is shut down.
Hazardous Combustion Products:
In operation, batteries generate and release flammable hydrogen gas. They must always be assumed to contain this gas which, if
ignited by burning cigarette, naked flame or spark, may cause battery explosion with dispersion of casing fragments and corrosive
liquid electrolyte. Carefully follow manufacturer's instructions for installation and service. Keep away all sources of gas ignition
and do not allow metallic articles to simultaneously contact the negative and positive terminals of a battery.
VI. ACCIDENTAL RELEASE MEASURES
Remove combustible materials and all sources of ignition. Stop flow of material and contain spill by diking with soda ash, etc. Carefully
neutralize spill with soda ash, etc. Make certain mixture is neutral then collect residue and place in a drum or other suitable container with
a label specifying "contains hazardous waste" or (if uncertain call distributor regarding proper labeling procedures). Dispose of as
hazardous waste. If battery is leaking, place battery in a heavy duty plastic bag. Wear acid resistant boots, face shield, chemical splash
goggles and acid resistant gloves. Do not allow discharge of acid to sewer. Acid must be managed in accordance with approved local,
state, and federal requirements. Consult state environmental agency and/or federal EPA.
VII. HANDLING AND STORAGE
Handling:
Single batteries pose no risk of electric shock but there may be increasing risk of electric shock from strings of connected batteries
exceeding three 12-volt units. Batteries are non-spillable - potential for exposure to contents only during recycling or if outer casing
is cracked or damaged.
Storage:
Store batteries under roof in cool, dry, well-ventilated areas that are separated from incompatible materials and from activities which
may create flames, sparks, or heat. Keep away from metallic objects that could bridge the terminals on a battery and create a
dangerous short-circuit.
Charging:
There is a possible risk of electric shock from charging equipment and from strings of series connected batteries, whether or not being
charged. Shut-off power to chargers whenever not in use and before detachment of any circuit connections. Batteries being charged
will generate and release flammable hydrogen gas. Charging space should be ventilated. Keep battery vent caps in position. Prohibit
smoking and avoid creation of flames and sparks nearby. Wear face and eye protection when near batteries being charged.
VIII. EXPOSURE CONTROLS AND PERSONAL PROTECTION
Occupational Exposure Limits (mg/m
3
)