Service manual

46 Chapter 6: Replacement Procedures

• Nest Frame Assembly, M-Turbo (Compatible with EDGE system):

• P07750 Nest Frame Assembly

• P00364 Connector, Interposer (8x)

• P03833 Shield, Perimeter, Short (2x)

• P03834 Shield, Perimeter, Long (2x)

• P00924 Screw, Shoulder, Thrust Plate (4x)

• P00353 Wear Plate

• P00646 Spring, Thrust Plate, .047 wire (4x)

• P08200 Socket Head Cap Screw, M2.5-.45x10mm (4x)

Required Tools

• #1 Phillips screwdriver

• #2 Phillips screwdriver

• Torque screwdriver, 2.0-10.0 inch pounds (0.23-1.1 Newton meter)

•2 mm allen key

• An anti-static mat

• A wrist grounding strap

Caution:

Always use correct ESD procedures. ESD damage is cumulative and may not be noticeable at first. Initial ESD

symptoms may be slightly degraded performance or image quality.

System Disassembly

1 Remove the battery.

2 Remove the Bottom Enclosure from the system following the removal procedures in “Display Removal” on

page 39.

3 Remove the Top Enclosure and Control Panel from the system following the removal procedures in “Display

Removal” on page 40.

4 Follow the cable removal from the procedure in “Display Removal” on page 42. This exposes all of the

replacement parts for the main system per Figure 6.9.

Major System Components

Figure 6.9 System Components

Fan

Nest Frame Assembly

Power Supply

(under shield)

Speaker

Main PCBA

USB Extension

CB Assembly

SD Card

Daughter-card

under shield)

Speaker