User guide

2 Preparing the system
To install the battery
1 Disconnect the power supply from the
ultrasound system.
2 Remove the system from the mini-dock (if
present) and turn it upside down.
3 Place the battery into the battery compartment,
at a slight angle. See Figure 3.
4 Slide the battery forward until it locks into place.
5 Slide the two locking levers outward to secure
the battery.
Figure 3 Install the Battery
To remove the battery
1 Disconnect the power supply from the
ultrasound system.
2 Remove the system from the mini-dock (if
present) and turn it upside down.
3 Pull up the two locking levers.
4 Slide the battery back.
5 Lift the battery from the compartment.
Using AC power and charging the
battery
The battery charges when the system is connected
to the AC power supply. A fully discharged battery
recharges in less than five hours.
The system can run on AC power and charge the
battery if AC power is connected to the system
directly, to a mini-dock, or to a docking system.
The system can run on battery power for up to two
hours, depending on the imaging mode and the
display brightness. When running on battery
power, the system may not restart if the battery is
low. To continue, connect the system to AC power.
To operate the system using AC power
1 Connect the DC power cable from the power
supply to the connector on the system. See
Figure 2 on page 1.
Push the cable in firmly to ensure a secure
attachment.
2 Connect the AC power cord to the power supply
and to a hospital-grade electrical outlet.
WARNING:
The equipment shall be connected
to a center-tapped single phase
supply circuit when users in the
United States connect the
equipment to a 240V supply
system.
Caution:
Verify that the hospital supply
voltage corresponds to the power
supply voltage range. See
“Electrical specifications” on
page 117.