ECIS4500 series Web Management Guide R02

Command Descriptions
161
This page allows for controlling VLAN configuration on the switch.
The page is divided into a global section and a per-port configuration section.
Object
Description
Global VLAN Configuration
Allowed Access VLANs
This field shows the allowed Access VLANs, i.e. it only affects ports configured as
Access ports. Ports in other modes are members of all VLANs specified in the
Allowed VLANs field. By default, only VLAN 1 is enabled. More VLANs may be
created by using a list syntax where the individual elements are separated by
commas. Ranges are specified with a dash separating the lower and upper bound.
The following example will create VLANs 1, 10, 11, 12, 13, 200, and 300:
1,10-13,200,300. Spaces are allowed in between the delimiters.
Ethertype for Custom
S-ports
This field specifies the ethertype/TPID (specified in hexadecimal) used for Custom
S-ports. The setting is in force for all ports whose Port Type is set to S-Custom-Port.
Port VLAN Configuration
Port
This is the logical port number of this row.
Mode
The port mode (default is Access) determines the fundamental behavior of the port in
question. A port can be in one of three modes as described below.
Whenever a particular mode is selected, the remaining fields in that row will be either
grayed out or made changeable depending on the mode in question.
Grayed out fields show the value that the port will get when the mode is applied.
Access:
Access ports are normally used to connect to end stations. Dynamic features like