CLI Reference Guide-R07

Chapter 8 | Authentication Commands
AAA
– 228 –
Example
Console(config)#aaa accounting dot1x default start-stop group radius
Console(config)#
aaa accounting exec This command enables the accounting of requested Exec services for network
access. Use the no form to disable the accounting service.
Syntax
aaa accounting exec {default | method-name}
start-stop group {radius | tacacs+ |server-group}
no aaa accounting exec {default | method-name}
default - Specifies the default accounting method for service requests.
method-name - Specifies an accounting method for service requests.
(Range: 1-64 characters)
start-stop - Records accounting from starting point and stopping point.
group - Specifies the server group to use.
radius - Specifies all RADIUS hosts configure with the radius-server
host command.
tacacs+ - Specifies all TACACS+ hosts configure with the tacacs-server
host command.
server-group - Specifies the name of a server group configured with the
aaa group server command. (Range:1-64characters)
Default Setting
Accounting is not enabled
No servers are specified
Command Mode
Global Configuration
Command Usage
◆ This command runs accounting for Exec service requests for the local console
and Telnet connections.
◆ Note that the default and method-name fields are only used to describe the
accounting method(s) configured on the specified RADIUS or TACACS+ servers,
and do not actually send any information to the servers about the methods to
use.
Example
Console(config)#aaa accounting exec default start-stop group tacacs+
Console(config)#