CLI Reference Guide-R07

Chapter 12 | Link Aggregation Commands
Dynamic Configuration Commands
– 392 –
Multicast Storm : Disabled
Multicast Storm Limit : 500 packets/second
Unknown Unicast Storm : Disabled
Unknown Unicast Storm Limit : 500 packets/second
Storm Threshold Resolution : 1 packets/second
Flow Control : Disabled
MAC Learning : Enabled
Link-up-down Trap : Enabled
Current status:
Created By : LACP
Link Status : Up
Port Operation Status : Up
Operation Speed-duplex : 1000full
Up Time : 0w 0d 0h 0m 53s (53 seconds)
Flow Control Type : None
Max Frame Size : 1518 bytes (1522 bytes for tagged frames)
MAC Learning Status : Enabled
Member Ports : Eth1/1, Eth1/2, Eth1/3,
Active Member Ports : Eth1/1, Eth1/2, Eth1/3,
Console#
lacp admin-key
(Ethernet Interface)
This command configures a port's LACP administration key. Use the no form to
restore the default setting.
Syntax
lacp {actor | partner} admin-key key
no lacp {actor | partner} admin-key
actor - The local side an aggregate link.
partner - The remote side of an aggregate link.
key - The port admin key must be set to the same value for ports that
belong to the same link aggregation group (LAG). (Range: 0-65535)
Default Setting
Actor: 1, Partner: 0
Command Mode
Interface Configuration (Ethernet)
Command Usage
◆ Ports are only allowed to join the same LAG if (1) the LACP system priority
matches, (2) the LACP port admin key matches, and (3) the LACP port channel
key matches (if configured).
◆ If the port channel admin key (lacp admin key - Port Channel) is not set when a
channel group is formed (i.e., it has the null value of 0), this key is set to the
same value as the port admin key (lacp admin key - Ethernet Interface) used
by the interfaces that joined the group.