CLI Reference Guide-R07

Chapter 16 | Loopback Detection Commands
– 433 –
Command Mode
Global Configuration
Command Usage
Refer to the loopback-detection recover-time command for information on
conditions which constitute loopback recovery.
Example
Console(config)#loopback-detection trap both
Console(config)#
loopback-detection
release
This command releases all interfaces currently shut down by the loopback
detection feature.
Syntax
loopback-detection release
Command Mode
Privileged Exec
Example
Console#loopback-detection release
Console(config)#
show loopback-
detection
This command shows loopback detection configuration settings for the switch or
for a specified interface.
Syntax
show loopback-detection [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10/28)
Command Mode
Privileged Exec
Example
Console#show loopback-detection
Loopback Detection Global Information
Global Status : Enabled
Transmit Interval : 10