CLI Reference Guide-R07

Chapter 28 | IP Routing Commands
Routing Information Protocol (RIP)
– 705 –
show ip protocols rip This command displays RIP process parameters.
Command Mode
Privileged Exec
Example
Console#show ip protocols rip
Routing Protocol is "rip"
Sending updates every 40 seconds with +/-5 seconds
Timeout after 240 seconds, garbage collect after 160 seconds
Outgoing update filter list for all interface is not set
Incoming update filter list for all interface is not set
Default redistribution metric is 1
Redistributing:
Default version control: send version by interface set,receive version by
inte
rface set
Interface Send Recv Bad Packets Bad Routes Send Updates
VLAN1 1-compatible 1 2 0 0 0
Routing for Networks:
10.0.0.0/14
Routing Information Sources:
Gateway Distance Last Update Version Bad Packets Bad Routes
The maximum number of RIP routes allowed: 20
Distance: Default is 120
Console#
show ip rip This command displays information about RIP routes and configuration settings.
Use this command without any keywords to display all RIP routes.
Syntax
show ip rip [interface [vlan vlan-id]]
interface - Shows RIP configuration settings for all interfaces or for a
specified interface.
vlan-id - VLAN ID. (Range: 1-4094)
Command Mode
Privileged Exec