CLI Reference Guide-R07

Chapter 2 | Using the Command Line Interface
Entering Commands
– 77 –
system will now display the “Console#” command prompt. You can also enter
Privileged Exec mode from within Normal Exec mode, by entering the enable
command, followed by the privileged level password “super.”
To enter Privileged Exec mode, enter the following user names and passwords:
Username: admin
Password: [admin login password]
CLI session with the ECS2100-28T is opened.
To end the CLI session, enter [Exit].
Console#
Username: guest
Password: [guest login password]
CLI session with the ECS2100-28T is opened.
To end the CLI session, enter [Exit].
Console>enable
Password: [privileged level password]
Console#
Configuration
Commands
Configuration commands are privileged level commands used to modify switch
settings. These commands modify the running configuration only and are not
saved when the switch is rebooted. To store the running configuration in non-
volatile storage, use the copy running-config startup-config command.
The configuration commands are organized into different modes:
◆ Global Configuration - These commands modify the system level configuration,
and include commands such as hostname and snmp-server community.
◆ Access Control List Configuration - These commands are used for packet
filtering.
◆ Class Map Configuration - Creates a DiffServ class map for a specified traffic
type.
◆ IGMP Profile - Sets a profile group and enters IGMP filter profile configuration
mode.
◆ Interface Configuration - These commands modify the port configuration such
as speed-duplex and negotiation.
◆ Line Configuration - These commands modify the console port and Telnet
configuration, and include command such as parity and databits.