Quick Start Guide-R03

– 1 –
1. Unpack the Switch and Check Contents
ECS2100-10T
ECS2100-10PE
ECS2100-10P
ECS2100-28T
ECS2100-28P
ECS2100-28PP
ECS2100-52T
ECS2110-26T
Rack Mounting Kit—two brackets and eight screws
Four adhesive foot pads
Power Cord—either Japan, US, Continental Europe
or UK
Console Cable—RJ-45 to DB-9 (Optional item)
Documentation—Quick Start Guide (this document)
and Safety and Regulatory Information
Note: The ECS2100 series switches are for indoor use only.
Note: For Safety and Regulatory information, refer to
the Safety and Regulatory Information document
included with the switch.
Note: Other documentation, including the
Installation Guide, Web Management Guide, and CLI
Reference Guide, can be obtained from www.edge-
core.com.
2. Mount the Switch
a. Mounting in a Rack
2
1
Attach the brackets to the switch.
Use the screws and cage nuts supplied with the rack to
secure the switch in the rack.
Caution: Installing the switch in a rack requires two people.
One person should position the switch in the rack, while the
other secures it using the rack screws.
Attention: Deux personnes sont nécessaires pour installer
un commutateur dans un bâti: La première personne va
positionner le commutateur dans le bâti, la seconde va le
fixer avec des vis de montage.
Note: The switch can also be installed on a desktop or shelf
using the included adhesive rubber foot pads.
b. Mounting in a Rack (ECS2100-10PE only)
Caution: For safe operation, install the switch with RJ-45
ports facing up.
Attention: Pour un fonctionnement sûr, installez le
commutateur avec les ports RJ-45 orientés vers le haut.
Set two screws in the wall 150 mm (5.9 in.) apart.
Slide the switch’s wall mounting slots down onto the screws
so that the unit is secure.
3. Ground the Switch
Ensure the rack on which the switch is to be mounted is
properly grounded and in compliance with ETSI ETS 300 253.
Verify that there is a good electrical connection to the
grounding point on the rack (no paint or isolating surface
treatment).
Attach a lug (not provided) to a #12 AWG (PoE switch) or #18
AWG (non-PoE switch) minimum grounding wire (not
provided), and connect it to the grounding point on the
switch rear panel. Then connect the other end of the wire to
rack ground.
1
2
2
1
1
2
1
2
1
2
E122022-AP-R03
150200001754A www.edge-core.com
10/28/52-Port Web-Smart Pro Gigabit Ethernet Switch
26-Port Web-Smart Pro 10G Ethernet Switch
Quick Start Guide