CLI Reference Guide-R07

Chapter 21 | Class of Service Commands
Priority Commands (Layer 3 and 4)
– 517 –
show qos map dscp-
queue
This command shows the ingress DSCP to eqress queue map.
Syntax
show qos map dscp-queue interface interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10/28)
Command Mode
Privileged Exec
Command Usage
This map is only used when the QoS mapping mode is set to “DSCP” by the qos
map trust-mode command, and the ingress packet type is IPv4.
Example
The ingress DSCP is composed of ingress-dscp10 (most significant digit in the left
column) and ingress-dscp1 (least significant digit in the top row (in other words,
ingress-dscp = ingress-dscp10 * 10 + ingress-dscp1); and the corresponding dscp is
shown at the intersecting cell in the table.
Console#show qos map dscp-queue interface ethernet 1/1
Information of Eth 1/1
DSCP to queue map.
d1:d2 0 1 2 3 4 5 6 7 8 9
----------------------------------------------
0 : 2 2 2 2 2 2 2 2 0 0
1 : 0 0 0 0 0 0 1 1 1 1
2 : 1 1 1 1 3 3 3 3 3 3
3 : 3 3 4 4 4 4 4 4 4 4
4 : 5 5 5 5 5 5 5 5 6 6
5 : 6 6 6 6 6 6 7 7 7 7
6 : 7 7 7 7
Console#
show qos map
trust-mode
This command shows the QoS mapping mode.
Syntax
show qos map trust-mode interface interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10/28)