CLI Reference Guide-R07

Chapter 23 | Multicast Filtering Commands
IGMP Filtering and Throttling
– 558 –
be assigned to one interface. Each profile has only one access mode; either permit
or deny.
Example
Console(config)#ip igmp profile 19
Console(config-igmp-profile)#
permit, deny This command sets the access mode for an IGMP filter profile.
Syntax
{permit | deny}
Default Setting
Deny
Command Mode
IGMP Profile Configuration
Command Usage
◆ Each profile has only one access mode; either permit or deny.
◆ When the access mode is set to permit, IGMP join reports are processed when a
multicast group falls within the controlled range. When the access mode is set
to deny, IGMP join reports are only processed when a multicast group is not in
the controlled range.
Example
Console(config)#ip igmp profile 19
Console(config-igmp-profile)#permit
Console(config-igmp-profile)#
range This command specifies multicast group addresses for a profile. Use the no form to
delete addresses from a profile.
Syntax
[no] range low-ip-address [high-ip-address]
low-ip-address - A valid IP address of a multicast group or start of a group
range.
high-ip-address - A valid IP address for the end of a multicast group range.
Default Setting
None