ECS3510-28T_Management Guide-R05

C HAPTER 13 | Security Measures
Access Control Lists
– 366 –
WEB INTERFACE
To add rules to an ARP ACL:
1. Click Security, ACL.
2. Select Configure ACL from the Step list.
3. Select Add Rule from the Action list.
4. Select ARP from the Type list.
5. Select the name of an ACL from the Name list.
6. Specify the action (i.e., Permit or Deny).
7. Select the packet type (Request, Response, All).
8. Select the address type (Any, Host, or IP).
9. If you select “Host,” enter a specific address (e.g., 11-22-33-44-55-
66). If you select “IP,” enter a base address and a hexadecimal bit mask
for an address range.
10. Enable logging if required.
11. Click Apply.
Figure 197: Configuring a ARP ACL