ECS3510-28T_Management Guide-R05

C HAPTER 14 | Basic Administration Protocols
Link Layer Discovery Protocol
– 429 –
CONFIGURING
LLDP INTERFACE
CIVIC-ADDRESS
Use the Administration > LLDP (Configure Interface – Add CA-Type) page
to specify the physical location of the device attached to an interface.
CLI REFERENCES
◆ "lldp med-location civic-addr" on page 1300
COMMAND USAGE
◆ Use the Civic Address type (CA-Type) to advertise the physical location
of the device attached to an interface, including items such as the city,
street number, building and room information. The address location is
specified as a type and value pair, with the civic address type defined in
RFC 4776. The following table describes some of the CA type numbers
and provides examples.
◆ Any number of CA type and value pairs can be specified for the civic
address location, as long as the total does not exceed 250 characters.
PARAMETERS
These parameters are displayed in the web interface:
◆ CA-Type – Descriptor of the data civic address value. (Range: 0-255)
◆ CA-Value – Description of a location. (Range: 1-32 characters)
WEB INTERFACE
To specify the physical location of the attached device:
1. Click Administration, LLDP.
2. Select Configure Interface from the Step list.
Table 25: LLDP MED Location CA Types
CA Type Description CA Value Example
1 National subdivisions (state, canton, province) California
2 County, parish Orange
3 City, township Irvine
4 City division, borough, city district West Irvine
5 Neighborhood, block Riverside
6 Group of streets below the neighborhood level Exchange
18 Street suffix or type Avenue
19 House number 320
20 House number suffix A
21 Landmark or vanity address Tech Center
26 Unit (apartment, suite) Apt 519
27 Floor 5
28 Room 509B