ECS4100 Series CLI Reference Guide-R07

– 447 –
13 Power over Ethernet Commands
The commands in this group control the power that can be delivered to attached
PoE devices listed on page 2.
The switch’s power management enables total switch power and individual port
power to be controlled within a configured power budget. Port power can be
automatically turned on and off for connected devices, and a per-port power
priority can be set so that the switch never exceeds its allocated power budget.
When a device is connected to a switch port, its power requirements are detected
by the switch before power is supplied. If the power required by a device exceeds
the power budget of the port or the whole switch, power is not supplied.
Table 83: PoE Commands
Command Function Mode
power inline compatible Provides power to pre-standard PoE devices GC
power inline
maximum allocation
Sets the maximum power allocation mode based on PD class
or user configuration
GC
power mainpower
maximum allocation
Sets the maximum power available to all switch ports GC
power inline Turns power on and off for specific ports IC
power inline
maximum allocation
Sets the maximum power available to specific switch ports IC
power inline priority Sets the priority for power supplied to specific ports IC
power inline time-range Binds a time-range to a port during which PoE is supplied IC
led-port-mode Controls the behavior of the PoE Ethernet port link activity
LEDs.
PE
show power inline status Displays the current status of power management on specific
ports or all ports
PE
show power mainpower Displays the current status of power management for switch PE
show power inline
time-range
Shows the time-range and current status for specific ports or
for all ports
PE