ECS4100 Series CLI Reference Guide-R07

Chapter 24 | ERPS Commands
– 610 –
exclusion-vlan Use this command to specify VLAN groups that are to be on the exclusion list of a
physical ERPS ring. Use the no form of the command to remove VLAN groups from
the list.
Syntax
[no] inclusion-vlan vlan-group-name
vlan-group-name - Name of the VLAN group. (Range: 1-12 characters)
Default Setting
None
Command Mode
ERPS Ring Configuration
Command Usage
◆ VLANs that are on the exclusion list are not protected by the ERPS ring.
◆ Any VLAN not listed on either the inclusion or exclusion list will be blocked on
ring ports.
◆ Use the show erps statistics command to view the exclusion-vlan list of VLAN
IDs.
◆ Traffic from control VLANs, inclusion VLANs, and exclusion VLANs of an ERPS
ring will be forwarded by non-ERPS ring ports.
Example
Console(config-erps)#exclusion-vlan vlgroup3
Console(config-erps)#
enable (ring) This command activates the current ERPS ring. Use the no form to disable the
current ring.
Syntax
[no] enable
Default Setting
Disabled
Command Mode
ERPS Ring Configuration
Command Usage
◆ Before enabling a ring, the global ERPS function should be enabled with the
erps command, the east and west ring ports configured on each node with the
ring-port command, the RPL owner specified with the rpl owner command,
and the control VLAN configured with the control-vlan command.