ECS4100 Series CLI Reference Guide-R07

Chapter 24 | ERPS Commands
– 626 –
version This command specifies compatibility with ERPS version 1 or 2.
Syntax
version {1 | 2}
no version
1 - ERPS version 1 based on ITU-T G.8032/Y.1344.
2 - ERPS version 2 based on ITU-T G.8032/Y.1344 Version 2.
Default Setting
2
Command Mode
ERPS Instance Configuration
Command Usage
◆ In addition to the basic features provided by version 1, version 2 also supports:
■
Multi-ring/ladder network support
■
Revertive/Non-revertive recovery
■
Forced Switch (FS) and Manual Switch (MS) commands for manually
blocking a particular ring port
■
Flush FDB (forwarding database) logic which reduces amount of flush FDB
operations in the ring
■
Support of multiple ERP instances on a single ring
◆ Version 2 is backward compatible with Version 1. If version 2 is specified, the
inputs and commands are forwarded transparently. If set to version 1, MS and
FS operator commands are filtered, and the switch set to revertive mode.
◆ The version number is automatically set to “1” when a ring node, supporting
only the functionalities of G.8032v1, exists on the same ring with other nodes
that support G.8032v2.
◆ When ring nodes running G.8032v1 and G.8032v2 co-exist on a ring, the ring ID
of each node is configured as “1”.
◆ In version 1, the MAC address 01-19-A7-00-00-01 is used for the node identifier.
The raps-def-mac command has no effect.
Example
Console(config-erps-inst)#version 1
Console(config-erps-inst)#